Truck & Jeep Parts Under $25 – tagged "electrical-lighting-and-accessories" – Page 24

Oracle 7443 18 LED 3-Chip SMD Bulb (Single) - Cool White SEE WARRANTY $16.80

ORACLE Turn Signal LED Bulbs are Direct OEM Replacement Bulbs that feature a Quick-Fire response, are brighter than stock halogen bulbs and include a 1 year warranty. The ORACLE line of SMD replacement bulbs features an unsurpassed level of brightness and quality. This bulb utilizes 5050 SMD technology which produces vibrant light with sharp hues while consuming only 1/10th of the power of the factory bulb. These 5050 SMD chips are rated at 100,000 hours for continuous use. Turn signal SMD bulbs will require the use of a "Load Equalizer" in order to prevent "rapid-flash". If using this bulb in brake light, reverse light, running light, etc. you will not need to add a load equalizer. SMDs increase safety when used in tail lights because they illuminate faster than incandescent bulbs.Installation Instructions

Oracle 7443 18 LED 3-Chip SMD Bulb (Single) - Red SEE WARRANTY $16.80

An intensively bright set of lights to replace your factory halogen bulbs. Depending on your vehicle's year, make and model, these bulbs are typically located in the: Headlights, Fog Lights, Tail Lights, or Turn Signals.

Oracle Adhesion Promoter Applicator Pads SEE WARRANTY $3.75

Sold as singles. New from ORACLE Lighting is a new convenient applicator system for tape adhesion promoter. This liquid primer is used to bond tape to common automotive surfaces, including Acrylic, ABS, PC, and Glass. Designed to be used with a wide variety of VHB foam tapes. Storage: Store in cool area out of direct sunlight. Application Tips: The bonding surface should be clean and dry. Contaminated surfaces should be cleaned with an untreated, lint-free cloth or to remove residue (wax, grease, dirt) use an isopropyl alcohol or paint prep solvent. Do not use in environmental conditions lower than 558F. Apply a thin, uniform coating to the bonding surface, using the minimum amount that will fully coat the surface. Apply promoter only to areas that will be fully covered with tape. Although drying times may vary due to temperature and/or humidity, a drying time of 30-90 seconds is typically indicative of this thickness. The primer should be dry before applying tape. For best results, apply tape immediately after primer applica- tion or no more than one hour after primer application. Be sure the primed surface remains free from contaminants prior to tape application. Note: If the primer comes into contact with a painted surface clean the area with soap and water, do not allow liquid to sit on the painted finish. Features: Increases bonding effectiveness of double stick tapes. Convenient packet applicator is easy to use. Dries in approximately 30 seconds. One packet covers approximately 1 Sq/Ft.

Oracle Authorized Dealer Bumper Sticker - Black/Orange SEE WARRANTY $2.75

Are you an Official Authorized Dealer for ORACLE Lighting Products These Bumper Decals are only offered exclusively to our vendors!

Oracle AWG 2 Conductor LED Installation Wire (Sold by the Foot) - Single Color SEE WARRANTY $1.26

ORACLE Lighting now offers quality wiring specifically for LED lighting projects. The conductor material in this wire is made from high-purity oxygen free copper (OFC), which is recognized as one of Earth's finest conductive metals. This is to insure the best connections for your lighting projects that will last for years without corrosion or eventual degradation of the copper conductor. For most applications of single color LEDs, 20AWG wiring is ideal. The capacity of the wire is more than ample for the low current draw of LEDs. American Wire Gauge (AWG), a wire sizing system, assigns numbers (which range from 0 to 40) to standardized wire thicknesses. In the AWG system, the higher the number, the thinner the wire. For multi-color LEDs you will need to use a 4-conductor wire, which uses a thinner gauge 22AWG cable ideal for ColorSHIFT(tm) LED projects. Product Specs: High Performance Cable Oxygen-Free Copper (OFC) Ideal for Single Color LEDs Sold by the Ft. or by the Spool (Contact our Sales Staff for pricing by the Ft.) 328 Ft. of Wire per Spool 2 Conductor 20AWG